[modeleng] Re: drawing identity
- From: "Alan Stepney" <alan@xxxxxxxxxxxxxxxx>
- To: <modeleng@xxxxxxxxxxxxx>
- Date: Mon, 26 Jan 2009 10:15:29 -0000
Indeed there is enough information to build one.
What isnt obvious from the scan is that there are numerous measurements on
the drawing.
Small, and hard to decipher in some cases, but enough can be read to give a
good start.
The drivers dont appear to be equalised as you said.
From the sanders on both sides of the centre driver, I assume it was
intended for frequent running in both directions.
The brake cylinder is shown as 21" diameter, which indicates vcuum rather
than air brakes.
Alan
----- Original Message -----
From: "Jesse Livingston" <fernj1@xxxxxxxxxxx>
To: <modeleng@xxxxxxxxxxxxx>
Sent: Monday, January 26, 2009 1:25 AM
Subject: [modeleng] Re: drawing identity
Alan,
Very nice find indeed. Enough information there to build a copy with no
problems. One curious thing, it did not seem to have had equalized drivers
or maybe I don't know what I am looking for.
Jesse in cold Troy, TN USA
MODEL ENGINEERING DISCUSSION LIST.
To UNSUBSCRIBE from this list, send a blank email to,
modeleng-request@xxxxxxxxxxxxx with the word "unsubscribe" in the subject line.
Other related posts: