[modeleng] Re: Wood stain removing/blending

Well, it's making Miss Peggy happy at least!! 
And---while a coat of finish was drying, I found some
time to start work on the steam distribution plate for
the Ugly V/O Engine.

Al
--- Terry Lane <tel@xxxxxxxxxxx> wrote:

> 
> I too have been there, done that - MUCH prefer to
> set meself alight & jump
> orf a cliff
> 
> 
> > Been there and done that Al! I would rather work
> on a model steam engine
> > too!
> >
> > Tony Wells.
> >
> > ----- Original Message -----
> > From: "Allen Messer" <al_messer@xxxxxxxxx>
> > To: <modeleng@xxxxxxxxxxxxx>
> > Sent: Tuesday, October 26, 2004 3:50 PM
> > Subject: [modeleng] Re: Wood stain
> removing/blending
> >
> >
> > > Thanks gents!  After another cup of Coffee, I
> shall go
> > > down to the shop and try out your ideas.  One
> bright
> > > thing about it, if I foul up too badly, I can
> turn
> > > that side to the inside of the closet!! 
> FYI--when
> > > this house was built back in the late '60's, all
> the
> > > doors were those "Flush Luan Mahogany" doors
> that were
> > > all the rage (and probably the cheapest the
> contractor
> > > could buy) back then.  We are in the process of
> > > replacing them all with "Six Panel Solid Pine
> Doors",
> > > and thus the need for staining them.  Also,
> since
> > > these doors weigh considerably more than the
> original
> > > ones, I am having to install an additional hinge
> in
> > > the center of each to support the extra weight. 
> Loads
> > > of fun----I'd much rather be working on a Model
> Steam
> > > Engine!!
> > >
> > > Al
> >
> >
> > MODEL ENGINEERING DISCUSSION LIST.
> >
> > To UNSUBSCRIBE from this list, send a blank email
> to,
> > modeleng-request@xxxxxxxxxxxxx with the word
> "unsubscribe" in the subject
> line.
> >
> 
> MODEL ENGINEERING DISCUSSION LIST.
> 
> To UNSUBSCRIBE from this list, send a blank email
> to, 
> modeleng-request@xxxxxxxxxxxxx with the word
> "unsubscribe" in the subject line.
> 



                
__________________________________
Do you Yahoo!?
Yahoo! Mail Address AutoComplete - You start. We finish.
http://promotions.yahoo.com/new_mail 
MODEL ENGINEERING DISCUSSION LIST.

To UNSUBSCRIBE from this list, send a blank email to, 
modeleng-request@xxxxxxxxxxxxx with the word "unsubscribe" in the subject line.

Other related posts: