[modeleng] Re: Winson Jubillee

It all sounds fine to me but then 25 years ago I was presented with a 
Stetson by the guys I used to share a lab with.

More interesting maybe is the story of the Kodak MES chaired by KN Harris 
which built a loco to within a gnats'. KN (for whom I had the highest 
respect as it happened) had been taking the Australian beer out of a tired 
old loco with play in every joint which ran nearby. They connected the pair 
of them up to the shop air supply and ran them over the floor. One wheezed 
gently and the went other like me when the FD is **really** cross. Trouble 
is that KN and his mates had built the slow one

>From: "Jeff Dayman" <jeffdayman@xxxxxxxxxxxx>
>
>Let's not forget the ever popular cotton rag wound tight around pesky steam
>leaks either.
>
>Cheers Jeff
>
>
>----- Original Message -----
>From: "Terry Lane" <tel@xxxxxxxxxxx>
>To: <modeleng@xxxxxxxxxxxxx>
>Sent: Wednesday, January 26, 2005 3:39 PM
>Subject: [modeleng] Re: Winson Jubillee
>
>
> > That's how it's supposed to be done - dincha ever watch 'African Queen'?
> >
> >
> > > At 07:31 PM 1/26/05 -0000, you wrote:
> > > >he was apparently a decent geezer but his frequent use of a hammer
> > > >resolve "minor problems" on his loco were a bit of a worry!
> > >
> > >      Sounds vaguely like a couple of folks in my club.  :-o
> > >
> > > Regards,
> > > Harry
> > >
> > > MODEL ENGINEERING DISCUSSION LIST.
> > >
> > > To UNSUBSCRIBE from this list, send a blank email to,
> > > modeleng-request@xxxxxxxxxxxxx with the word "unsubscribe" in the
>subject
> > line.
> > >
> >
> > MODEL ENGINEERING DISCUSSION LIST.
> >
> > To UNSUBSCRIBE from this list, send a blank email to,
> > modeleng-request@xxxxxxxxxxxxx with the word "unsubscribe" in the 
>subject
>line.
>
>MODEL ENGINEERING DISCUSSION LIST.
>
>To UNSUBSCRIBE from this list, send a blank email to,
>modeleng-request@xxxxxxxxxxxxx with the word "unsubscribe" in the subject 
>line.


MODEL ENGINEERING DISCUSSION LIST.

To UNSUBSCRIBE from this list, send a blank email to, 
modeleng-request@xxxxxxxxxxxxx with the word "unsubscribe" in the subject line.

Other related posts: