[modeleng] Re: Turning cork

That's what I like to see - a bit of lateral thinkin'



> My advice would be to keep on buying bottles with corks of different
> sizes until you find one that fits.
>
> Hic!
>
> Peter
>
> alan stepney wrote:
> > Has anyone any experience of turning cork.
> >
> > Yesterday I needed to turn a small round "bung".
> > None of my efforts produced a decent finish, and
> > eventually I carved / hacked it out with a craft knife.
> >
> > However, I am sure that it can be turned; after all, corks for bottles
must
> > be made in some way.
> >
> >
> > So, how?
> >
> > Alan Stepney
> >
> > http://www.alanstepney.info
> > Model Engineering & steam engine information pages
> >
> > MODEL ENGINEERING DISCUSSION LIST.
> >
> > To UNSUBSCRIBE from this list, send a blank email to,
> > modeleng-request@xxxxxxxxxxxxx with the word "unsubscribe" in the
subject line.
> >
> >
> >
>
> MODEL ENGINEERING DISCUSSION LIST.
>
> To UNSUBSCRIBE from this list, send a blank email to,
> modeleng-request@xxxxxxxxxxxxx with the word "unsubscribe" in the subject
line.
>

MODEL ENGINEERING DISCUSSION LIST.

To UNSUBSCRIBE from this list, send a blank email to, 
modeleng-request@xxxxxxxxxxxxx with the word "unsubscribe" in the subject line.

Other related posts: