[modeleng] Re: Split pins

Alan,

Depends on the size. If it is typical model engineering size I would get 
some wire of the required diameter, file it to a half round section then 
heat it up and bend it round a bit of piano wire.

Barrie

> It is probably a stupid question, but does anyone know precisely how they
> are made?
>
> Also, if you had to make a small quantity (dozens rather than hundreds) 
> how
> would you do it?
>
> Alan
>
> MODEL ENGINEERING DISCUSSION LIST.
>
> To UNSUBSCRIBE from this list, send a blank email to,
> modeleng-request@xxxxxxxxxxxxx with the word "unsubscribe" in the subject 
> line.
>
>
>
> -- 
> No virus found in this incoming message.
> Checked by AVG Free Edition.
> Version: 7.5.516 / Virus Database: 269.20.6/1282 - Release Date: 
> 15/02/2008 19:08
>
> 

MODEL ENGINEERING DISCUSSION LIST.

To UNSUBSCRIBE from this list, send a blank email to, 
modeleng-request@xxxxxxxxxxxxx with the word "unsubscribe" in the subject line.

Other related posts: