[modeleng] Re: Split pins

Now that looks like a handy bit of kit to own Chas.


> Use a jeweler's drawplate?
>
http://cgi.ebay.com/30-Half-Round-Hole-Drawplate-Jewelers-Wire-Drawing-Tool_
W0QQitemZ360023788127QQihZ023QQcategoryZ10323QQssPageNameZWDVWQQrdZ1QQcmdZVi
ewItem
>
> Charles
> -------------- Original message --------------
> From: "TEL" <tel47@xxxxxxxxxxx>
>
> > Or you can draw it though a hole drilled in a block, with and end mill
> > spinning in a second hole in the side at 1/2 depth
> >
> >
> > >
> > > Hmmmm......a hundred.........filing wire into a "D" section could be a
tad
> > > tedious. How about wrapping the wire nice and tightly round a true
running
> > > piece of largish diameter bar in the lathe. It should then be a fairly
> > > straightforward job to reduce the wire to a "D" section.
> > >
> > > Barrie
>
> MODEL ENGINEERING DISCUSSION LIST.
>
> To UNSUBSCRIBE from this list, send a blank email to,
> modeleng-request@xxxxxxxxxxxxx with the word "unsubscribe" in the subject
line
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>

MODEL ENGINEERING DISCUSSION LIST.

To UNSUBSCRIBE from this list, send a blank email to, 
modeleng-request@xxxxxxxxxxxxx with the word "unsubscribe" in the subject line.

Other related posts: