[modeleng] Re: Split pins

Probably wrap a piece of wire that was red hot in the middle around a
pin, hold the ends together and use an appropriate pair of pliers to
crimp down just under the head leaving the legs parallel
chrisc

> -----Original Message-----
> From: modeleng-bounce@xxxxxxxxxxxxx
[mailto:modeleng-bounce@xxxxxxxxxxxxx]
> On Behalf Of Alan Stepney
> Sent: 16 February 2008 16:18
> To: modeleng@xxxxxxxxxxxxx
> Subject: [modeleng] Split pins
> 
> It is probably a stupid question, but does anyone know precisely how
they
> are made?
> 
> Also, if you had to make a small quantity (dozens rather than
hundreds)
> how
> would you do it?
> 
> Alan
> 
> MODEL ENGINEERING DISCUSSION LIST.
> 
> To UNSUBSCRIBE from this list, send a blank email to,
> modeleng-request@xxxxxxxxxxxxx with the word "unsubscribe" in the
subject
> line.

________________________________________________________________________
This e-mail, and any attachment, is confidential. If you have received it in 
error, do not use or disclose the information in any way, notify me 
immediately, and please delete it from your system.
________________________________________________________________________
MODEL ENGINEERING DISCUSSION LIST.

To UNSUBSCRIBE from this list, send a blank email to, 
modeleng-request@xxxxxxxxxxxxx with the word "unsubscribe" in the subject line.

Other related posts: