[modeleng] Simple Question

From: "Barrie Purslow" <bpduo@xxxxxxxxxxxxx>
To: "Model Engineering List" <modeleng@xxxxxxxxxxxxx>
Date: Fri, 19 Jun 2009 21:06:46 +0100

Whenever I use an adjustable spanner I always make sure the jaws are adjusted 
to be a snug fit on a hexagon. But why is it that when I remove the spanner 
from the hex. I cannot get it on again without increasing the jaw spacing?
Barrie
MODEL ENGINEERING DISCUSSION LIST.

To UNSUBSCRIBE from this list, send a blank email to, 
modeleng-request@xxxxxxxxxxxxx with the word "unsubscribe" in the subject line.

Follow-Ups:

[modeleng] Re: Simple Question
From: TEL

[modeleng] Tapered opening on adjustable spanners
From: R.L. Roebuck

[modeleng] Re: Simple Question
From: Andrew Houston

[modeleng] Re: Simple Question
From: Jesse Livingston

[modeleng] Simple Question

Other related posts: