[modeleng] Re: Screwing the job up

My pleasure, but as the thread would be 2D off the fax it's likely to be a
bit lumpy in use.

Seriously, if you can't find any I could easily mail you an 8" chunk of
1/2"-13 UNC - I have some here. I'm sure you can find some locally very
cheap at an industrial supply house.

Let me know, Jeff




----- Original Message -----
From: "Peter Sheppard" <peter.sheppard@xxxxxxxxxx>
To: <modeleng@xxxxxxxxxxxxx>
Sent: Monday, April 18, 2005 7:49 AM
Subject: [modeleng] Re: Screwing the job up


> Jeff,
>
> Can you either fax or e-mail me a length please :-)
>
> Cheers
>
> Peter
>
> --------------------------------------------------------------------
> Peter Sheppard BSc (Hons) CEng FIEE FIRSE FSaRS
> Principal Consultant
> Lloyd's Register Rail Limited
> 5th Floor, 37-39 Corn Street
> Bristol BS1 1HT
>
> T: 0117 929 4443
> F: 0117 929 4554
> M: 07760 167 617
> E: peter.sheppard@xxxxxxxxxx
> --------------------------------------------------------------------
>
>
> On Monday, April 18, 2005 12:33 PM, Jeff Dayman
[SMTP:jeffdayman@xxxxxxxxxxxx]
> wrote:
> > Hi Peter,
> >
> > Not sure if it's available there in the size you need, but you might
> > consider a piece of purchased threaded rod. 1/2"-13 UNC would be close,
and
> > only a few dollars (and no trouble) for a 36" length here.
> >
> > Just a thought.
> >
> > Cheers, Jeff Dayman Waterloo Ontario Canada
> >
> >
>
>
> MODEL ENGINEERING DISCUSSION LIST.
>
> To UNSUBSCRIBE from this list, send a blank email to,
> modeleng-request@xxxxxxxxxxxxx with the word "unsubscribe" in the subject
line.
>

MODEL ENGINEERING DISCUSSION LIST.

To UNSUBSCRIBE from this list, send a blank email to, 
modeleng-request@xxxxxxxxxxxxx with the word "unsubscribe" in the subject line.

Other related posts: