[modeleng] Re: SVR

 Here is a photo of yours truly holding a tap in the SVR engineering shop.

2 1/4" BSW, and stamped GWR.

http://www.alanstepney.info/tap.jpg


Alan,

You reckon I could borrow that wee little tap to use on the exhaust port on 
a model engine I am building?????   But then, I wonder if the taper per inch 
would match my US standard pipe dies?

Jesse in summat warm Troy, TN, USA

MODEL ENGINEERING DISCUSSION LIST.

To UNSUBSCRIBE from this list, send a blank email to, 
modeleng-request@xxxxxxxxxxxxx with the word "unsubscribe" in the subject line.

Other related posts: