[modeleng] Re: SVR

I'm on the SVR dining special as we speak! Earlstoke Manor at the front!

Peter
(in Severn heaven !)

---Original Message-----
From: "Jeff D" <jeffdayman@xxxxxxxxxxxx>
To: modeleng@xxxxxxxxxxxxx
Sent: 24/06/08 20:03
Subject: [modeleng] Re: SVR

I was thinkin he might not have a wrench small enough for it...

Cheers Jeff Dayman


>From: "TEL" <tel47@xxxxxxxxxxx>
>Reply-To: modeleng@xxxxxxxxxxxxx
>To: <modeleng@xxxxxxxxxxxxx>
>Subject: [modeleng] Re: SVR
>Date: Wed, 25 Jun 2008 05:07:46 +1000
>
>It's a bit flimsy for you Unk - you'd snap it first go.
>
>
> > Here is a photo of yours truly holding a tap in the SVR engineering=20
>shop.
> >
> > 2 1/4" BSW, and stamped GWR.
> >
> > http://www.alanstepney.info/tap.jpg
> >
> >
> > Alan,
> >
> > You reckon I could borrow that wee little tap to use on the exhaust por=
t
>on
> > a model engine I am building?????   But then, I wonder if the taper per
>inch
> > would match my US standard pipe dies?
> >
> > Jesse in summat warm Troy, TN, USA
> >
> > MODEL ENGINEERING DISCUSSION LIST.
> >
> > To UNSUBSCRIBE from this list, send a blank email to,
> > modeleng-request@xxxxxxxxxxxxx with the word "unsubscribe" in the=20
>subject
>line.
> >
> >
> >
> >
> >
> >
> >
> >
> >
> >
> >
> >
> >
> >
> >
> >
> >
> >
> >
> >
> >
> >
> >
> >
> >
> >
> >
> >
> >
> >
> >
> >
> >
> >
> >
> >
> >
> >
> >
> >
> >
> >
> >
> >
> >
> >
> >
> >
> >
> >
> >
> >
> >
> >
> >
> >
> >
> >
> >
> >
> >
> >
> >
> >
> >
> >
> >
> >
> >
> >
> >
> >
> >
> >
> >
> >
> >
> >
> >
> >
> >
> >
> >
> >
> >
> >
> >
> >
> >
> >
> >
> >
> >
> >
> >
> >
> >
> >
> >
> >
> >
> >
> >
> >
> >
> >
> >
> >
> >
> >
> >
> >
> >
> >
> >
> >
> >
> >
> >
> >
> >
> >
> >


MODEL ENGINEERING DISCUSSION LIST.

To UNSUBSCRIBE from this list, send a blank email to, 
modeleng-request@xxxxxxxxxxxxx with the word "unsubscribe" in the subject line.

Other related posts: