[modeleng] Re: Rubber Seal

http://www.hexham.ndirect.co.uk/h305.html


----- Original Message ----- 
From: "kenny" <kenny.macdougall@xxxxxxxxxxxxxx>
To: <modeleng@xxxxxxxxxxxxx>
Sent: Monday, April 24, 2006 2:48 PM
Subject: Re: [modeleng] Rubber Seal


> Hi Peter got this info from a website hope it helps
> kenny
> http://www.e-teck.com/gasket.html
>
> ----- Original Message ----- 
> From: <psbr20252@xxxxxxxxxxxxxxxx>
> To: <modeleng@xxxxxxxxxxxxx>
> Sent: Monday, April 24, 2006 2:22 PM
> Subject: [modeleng] Rubber Seal
>
>
>>I am getting on with Topsy, but I have hit a minor snag=2E
>>
>> The petrol tank for Topsy has a sight glass held in place by a single 
>> thum=
>> b
>> screw and seals to the tank using a rubber seal=2E
>>
>> Therin lies the problem!  Over the years, the seal has dried out and is 
>> no=
>> w
>> brittle and hard as thus no longer seals=2E
>>
>> I need to replace it, but what with=3F  Would a rubber washer from a 
>> garde=
>> n
>> tap fitting do, or is the rubber in petrol fittings a particular compound
>> that is petrol resistant=3F
>>
>> Is there another material I could use=3F
>>
>> Cheers
>>
>> Peter=20
>>
>> --------------------------------------------------------------------
>> mail2web - Check your email from the web at
>> http://mail2web=2Ecom/ =2E
>>
>>
>> MODEL ENGINEERING DISCUSSION LIST.
>>
>> To UNSUBSCRIBE from this list, send a blank email to,
>> modeleng-request@xxxxxxxxxxxxx with the word "unsubscribe" in the subject 
>> line.
>>
> 


MODEL ENGINEERING DISCUSSION LIST.

To UNSUBSCRIBE from this list, send a blank email to, 
modeleng-request@xxxxxxxxxxxxx with the word "unsubscribe" in the subject line.

Other related posts: