[modeleng] Re: Nameplate niggles

I thought Diane Carneys were all Etched nameplates?

I use Dave Belshaw, based in Helmshore, Lancs.

Contact him on dbelshaw9@xxxxxxx, or 01706 216949

Craig

> Some Guy caled Pete waterman uses Bill for his engines, There are a couple
> of guys here lurking that have used Bill, perhaps thay would like to
> contribute?.... Mr Bramble?.....
>
> I can only go on quality and service, Both get a 100%+ from me .
> ----- Original Message -----
> From: "Harry Wade" <hww@xxxxxxxx>
> To: <modeleng@xxxxxxxxxxxxx>
> Sent: Tuesday, August 21, 2007 10:42 PM
> Subject: [modeleng] Re: Nameplate niggles
>
>
> At 10:30 PM 8/21/07 +0100, you wrote:
>>Bil Hall is cheaper and better quality - Dave
>
> Dave,
>       Cheaper is easily understood, but what about Bills' quality can be
> measureably better?  I've examined D. Carney's plates and don't find much
> room for improvement, unless her quality has slipped badly in the last few
> years.
>
> Regards,
> Harry
>
> MODEL ENGINEERING DISCUSSION LIST.
>
> To UNSUBSCRIBE from this list, send a blank email to,
> modeleng-request@xxxxxxxxxxxxx with the word "unsubscribe" in the subject
> line.
>
>
>
>
> MODEL ENGINEERING DISCUSSION LIST.
>
> To UNSUBSCRIBE from this list, send a blank email to,
> modeleng-request@xxxxxxxxxxxxx with the word "unsubscribe" in the subject
> line.
>
> --
> This email has been verified as Virus free
> Virus Protection and more available at http://www.plus.net
>


MODEL ENGINEERING DISCUSSION LIST.

To UNSUBSCRIBE from this list, send a blank email to, 
modeleng-request@xxxxxxxxxxxxx with the word "unsubscribe" in the subject line.

Other related posts: