[modeleng] Re: Mill info, was I might get into trouble.

Hi Keith very intrested were are you based and yes some photos please to
   
  stevecrees@xxxxxxxxxxx
   
  Many thanks 
  Steve C
Gmx22@xxxxxxx wrote:
  Ok this is info on mill, I bought it second hand , make APTC well that's 
what is on the side of it. Table size 23" x 7.5" . Table travel 6" x 15" Nose 
to 
table height 14.25". I was looking for £400
12 speed belt drive No 3 MT sorry only tooling with it is 1/2 chuck all 
other tooling i need for new machine. total height of mill is 40" and the stand 
is 31" Oh its 240 volt, (I wish I had 415) Its in quite goon nick with no real 
marks on the table but in no way is it a new bit of kit. Anyway if anyone 
interested I will email pics, don't want to waste your time on something that 
not any good to you. Tony yes it will come apart but the weight is at the top 
so god knows how you would get it back together. I have an engine crane so can 
move it about. when I collected it I used a small trailer.
As with all toys I could not wait to use it but after hours of looking, 
thinking and 20 cups of tea went and bought a small engine crane, which i might 
add has come in handy on numerous occasions. If you want more info I will email 
you and can have chat on phone 
Keith
MODEL ENGINEERING DISCUSSION LIST.

To UNSUBSCRIBE from this list, send a blank email to, 
modeleng-request@xxxxxxxxxxxxx with the word "unsubscribe" in the subject line.


                
---------------------------------
 Now you can scan emails quickly with a reading pane. Get the new Yahoo! Mail.

MODEL ENGINEERING DISCUSSION LIST.

To UNSUBSCRIBE from this list, send a blank email to, 
modeleng-request@xxxxxxxxxxxxx with the word "unsubscribe" in the subject line.

Other related posts: