[modeleng] Re: Lead Screw

Tel, I will send you a photo during the day,
John
----- Original Message -----
From: "TEL" <tel@xxxxxxxxxxx>
To: <modeleng@xxxxxxxxxxxxx>
Sent: Friday, October 27, 2006 5:53 AM
Subject: [modeleng] Re: Lead Screw


> John, I have an odd-bod feed screw here (ex eBay) that might or might not
be
> suitable - if you can give me the all the dimensions on the one you are
> lookin' for I'll run over it.
>
> ----- Original Message -----
> From: "John Buckley" <jbuckley@xxxxxxxxxxxxxxxxx>
> To: <modeleng@xxxxxxxxxxxxx>
> Sent: Friday, October 27, 2006 4:31 AM
> Subject: [modeleng] Lead Screw
>
>
> > Morning All,
> >
> > I am trying to source a cross slide lead screw for a Sheraton Conquest
> > lathe.
> >
> > It has powered cross feed which means the lead screw has a gear on it
> which
> > is integral to the thread.  the only way I can see to fix the proplem of
> > wear is to obtain a length of  11mm diam x 2mm LH pitch screwed ? acme
rod
> > and adapt it to the current lead screw.
> >
> > Does anyone know of a genuine leadscrew lying around the place or where
I
> > can get a lead screw.
> >
> > I have Googled and it would appear that the    11 mm x 2 mm is not a std
> > size.
> >
> > Cheers,
> > John
> >
> >
> > MODEL ENGINEERING DISCUSSION LIST.
> >
> > To UNSUBSCRIBE from this list, send a blank email to,
> > modeleng-request@xxxxxxxxxxxxx with the word "unsubscribe" in the
subject
> line.
> >
>
> MODEL ENGINEERING DISCUSSION LIST.
>
> To UNSUBSCRIBE from this list, send a blank email to,
> modeleng-request@xxxxxxxxxxxxx with the word "unsubscribe" in the subject
line.
>
>


MODEL ENGINEERING DISCUSSION LIST.

To UNSUBSCRIBE from this list, send a blank email to, 
modeleng-request@xxxxxxxxxxxxx with the word "unsubscribe" in the subject line.

Other related posts: