[modeleng] Re: Juliet's

Hello Phil

It may be worthwhile placing a free advert on that most helpful site: 
www.homeworkshop.org.uk
Who knows?    Someone may have some castings gathering dust.

Good luck.

Cheers!   Hubert

----- Original Message ----- 
From: "Phill Smith" <steam@xxxxxxxxxxxxxxxxxxxxxx>
To: <modeleng@xxxxxxxxxxxxx>
Sent: Monday, May 18, 2009 4:51 PM
Subject: [modeleng] Re: Juliet's


> G'Day Alan,
>
> The angle iron buffers is as LBSC originally designed it. They were
> originally brazed onto the side sheets. I don't like that, so I'll bolt 
> them
> with angle brackets.
>
> I was lucky I was sitting down when I went to the AJ Reeves site and 
> looked
> at thier prices for cylinder sets.... 177 pounds for 1 cylinder set!!!!!
> Just ONE cylinder set. They have just lost my business...... What a mob of
> thieves!!!!!!!!!!
> I hate patternmaking!!!! Oh well, looks like there is no choice now. 
> Unless
> I can find someone that has some patterns that they wouldn't mind lending
> me...... They would be rare these days.
>
> TEL, didn't you make a Juliet? Where did you get your castings from?
>
> Maybe I should concentrate on building a oil fired (I don't know if LPG
> would be hot enough) furnass first....... There's no shortage of good
> quality green sand around here......
> Anyone got any drawings for one? I had better get started, otherwise
> disapointment awaits the delayed start on the project.
>
>
> Cheers,
>
> Phill.
>
>
> 

MODEL ENGINEERING DISCUSSION LIST.

To UNSUBSCRIBE from this list, send a blank email to, 
modeleng-request@xxxxxxxxxxxxx with the word "unsubscribe" in the subject line.

Other related posts: