[modeleng] Re: Having a nice seat for your ball(s)

I drill the hole and then face a flat top on it with an endmill held in the
tailstock.  Put the ball in and do as Terry says, bash it by using a brass
rod and small hammer tap. I then use that same ball for the valve and have
no problems with leakage.

I missed the one about the Bloke with the Rolls and the Golf Tees, but I
have heard the one about the guy who went into a small country restaurant
and placed a couple of golf balls on the table while he dug out his money
for the waitress.


Jesse in USA
>
> I've never had much luck with that burnishing caper Peter - generally a
good
> bash will set 'em to rights

MODEL ENGINEERING DISCUSSION LIST.

To UNSUBSCRIBE from this list, send a blank email to, 
modeleng-request@xxxxxxxxxxxxx with the word "unsubscribe" in the subject line.

Other related posts: