[modeleng] Re: Electronic Speed Controllers

Hi Peter

Glad you fount the info helpful you could also try
http://www.parksiderailways.co.uk/index_Page835.htm
Kenny

----- Original Message ----- 
From: "Peter Sheppard" <peter@xxxxxxxxxxxxxxxxxxx>
To: <modeleng@xxxxxxxxxxxxx>
Sent: Tuesday, August 26, 2008 10:22 AM
Subject: [modeleng] Re: Electronic Speed Controllers


> Kenny,
>
> Good advice, thank you.  I just looked at the Uni 8 spec to see if there
> were any lower limits for the 24v controller (which there weren't!) I just
> wonder why 4QD could answer the question that way!
>
> It is for a friends locomotive which has a single Sinclair C5 motor, so
> running it on 24v shouldn't be a problem.  In fact I do know of one "Robot
> Wars" competitor that had one C5 motor driving one wheel (two in total)
> using a "bang bang" control forward an reverse on each C5 and 7 x 12v
> batteries giving a supply voltage of 84v.  At the end of the round the C5s
> were slightly warm and the batteries were shot!
>
> (It didn't half shift though!)
>
> Cheers
>
> Peter
>
>
>
>
>
> MODEL ENGINEERING DISCUSSION LIST.
>
> To UNSUBSCRIBE from this list, send a blank email to,
> modeleng-request@xxxxxxxxxxxxx with the word "unsubscribe" in the subject 
> line.
> 


MODEL ENGINEERING DISCUSSION LIST.

To UNSUBSCRIBE from this list, send a blank email to, 
modeleng-request@xxxxxxxxxxxxx with the word "unsubscribe" in the subject line.

Other related posts: