Prism2 cards are actually b only, and the network is only in g traffic. Wait for ralink cards to support injection. Yes, this is said to be the univeral solution to everything. But thats why we are doing it... On 4/18/07, Lawrence Bean <lbean@xxxxxxxxxxxxx> wrote:
kismac@xxxxxxxxxxxxx writes: >I'd go for the wusb11 if I were you. I've had the most luck with it. Hey Jake. I picked up a Linksys WUSB11 v2.5 and have just started playing with it and Kismac. I'm using a G3 iBook with 10.4.9, have downloaded/compiled 0.21a from the USB branch, and have not installed any other drivers. I have a WAP network (a linksys, average signal 36) within easy reach of my condo and touched base with the owner about running a sample hack ... to practice and to help them shore up their perimeter. I watched the video http://www.youtube.com/watch?v=G38PD5FyUxE and selected USB Device, passive mode as primary injection. I homed in on the main channel and hub, and after collecting a couple hundred data packets chose "Authentication Flood". When I do this, after about a minute the signal goes to zero and no further packets are collected. If I stop the flood, signal goes back to normal and packets are collected again. If I choose "reinject packets", I get a box saying "waiting for interesting packets" and packets continue to be collected, but after a while I get "unable to start a reinjection attack because the network seems not to be reacting". Do you have any hints for me, or can you describe a setup you know cracking WEP worked so I can verify my installation is correct?