what synthesizer? this problem used to be there on windows 98. Upgrade to win2k or later. At 10:30 AM 9/21/2004, Shane Hecker wrote: When I try to add a piece of hardware through the add new hardware wizzard, jaws will stop speaking. The only way I can get it talking again is by exiting the wizzard. The same thing happens when I try adding a printer through the add printer wizard. In the add new hardware wizzard, I get to the point where I tell it if the hardware is in the list. I can't go any further. In the add printer wizzard, I select local printer, push next, and the speech goes away. This happens regardless of what synthesizer I'm using. Everything else works perfectly. I'm using windows 98 se, on an amd 2600+, 256 mb ram, on a gigabyte ga7l motherboard. The board has the nforce ultra 400 chipset. Any help would be appreciated. Thanks. Shane -- To post a message to the list, send it to jfw@xxxxxxxxxxxxx To unsubscribe from this mailing list, send a message to jfw-request@xxxxxxxxxxxxx with the word unsubscribe in the subject line. Archives located at: //www.freelists.org/archives/jfw If you have any concerns about the list, post received from the list, or the way the list is being run, do not post them to the list. Rather contact the list owner at jfw-admins@xxxxxxxxxxxxxx --------------------------------------------------------------------------------------------------------------------------------------- Pranav -- To post a message to the list, send it to jfw@xxxxxxxxxxxxx To unsubscribe from this mailing list, send a message to jfw-request@xxxxxxxxxxxxx with the word unsubscribe in the subject line. Archives located at: //www.freelists.org/archives/jfw If you have any concerns about the list, post received from the list, or the way the list is being run, do not post them to the list. Rather contact the list owner at jfw-admins@xxxxxxxxxxxxxx