I understand all of that, but will I be able to use the other features such as IDS? ----- Original Message ----- From: "Quillman Shawn (RBNA/CIT7)" <Shawn.Quillman@xxxxxxxxxxxx> To: "[ISAserver.org Discussion List]" <isalist@xxxxxxxxxxxxx> Sent: Wednesday, September 11, 2002 9:38 AM Subject: [isalist] RE: ONE NIC?? http://www.ISAserver.org If you're just going to use it in cache mode one nic will work. It just means that your client apps have to support proxying, then configure them to point to your ISA. Then on the ISA either make sure the default route is set to your Internet gateway and configure your routing rule(s) to retrieve content direct from source, or configure routing rules to forward to an upstream proxy. Depends on what your gateway device is (router, separate firewall, etc). -Shawn ----- Shawn R. Quillman Robert Bosch Corporation RBNA/CIT7 38000 Hills Tech Drive Farmington Hills, MI 48331 (248) 553-1164 (P) (248) 848-2855 (F) shawn.quillman@xxxxxxxxxxxx -----Original Message----- From: Matthew Carpenter [mailto:giddyboy@xxxxxxxxxxx] Sent: Wednesday, September 11, 2002 10:31 AM To: [ISAserver.org Discussion List] Subject: [isalist] ONE NIC?? http://www.ISAserver.org I am reading through Dr. Shinder's book (thanks all for the suggestion) and I am looking over my install options. I do not really need the firewall feature, but I do want to use caching, proxy, and IDS features. Do I NEED 2 NICs to do that? I have one internal address for the machine I want to use, and do not really want to add a public address. I can adda NIC and put it on the DMZ, but is that necessary? Let me know your thoughts/experience. TIA ------------------------------------------------------ You are currently subscribed to this ISAserver.org Discussion List as: shawn.quillman@xxxxxxxxxxxx To unsubscribe send a blank email to $subst('Email.Unsub') ------------------------------------------------------ You are currently subscribed to this ISAserver.org Discussion List as: giddyboy@xxxxxxxxxxx To unsubscribe send a blank email to $subst('Email.Unsub')