You have to R-click on "Bandwidth Rules" select "Properties" and put a checkmark in "Enable Bandwidth Control" and enter the value in Kb/S for your external interface. You should also read up on "Determining effective bandwidth" in the ISA help. Lots of good info there... ..and I was hoping for a bug.. <snif> Jim Harrison MCP(NT4, 2K), A+, Network+, PCG http://isaserver.org/authors/harrison/ Read the book! ----- Original Message ----- From: Webmaster To: jim@xxxxxxxxxxxx Sent: Monday, December 31, 2001 13:34 Subject: Re: [isalist] Re: Bandwidth Priority Hi Jim, This is what I get out of your great utility TIA Richard ----- Original Message ----- From: Jim Harrison To: [ISAserver.org Discussion List] Sent: Monday, December 31, 2001 1:16 PM Subject: [isalist] Re: Bandwidth Priority http://www.ISAserver.org Sounds like either: 1. a bug report (the isainfo.txt would be helpful) 2. a configuration error (the isainfo.txt would still be helpful) ;-) Jim Harrison MCP(NT4, 2K), A+, Network+, PCG http://isaserver.org/authors/harrison/ Read the book! ----- Original Message ----- From: Webmaster To: [ISAserver.org Discussion List] Sent: Monday, December 31, 2001 12:43 Subject: [isalist] Bandwidth Priority http://www.ISAserver.org I thought that I had set up Bandwidth Priorities, but when I run Jim's handy Dandy isainfo utility it shows my bandwidth control is not enabled, but does show my banwidth rules Any thoughts TIA Richard p.s. Happy New Year To One And All ------------------------------------------------------ You are currently subscribed to this ISAserver.org Discussion List as: jim@xxxxxxxxxxxx To unsubscribe send a blank email to $subst('Email.Unsub') ------------------------------------------------------ You are currently subscribed to this ISAserver.org Discussion List as: webmaster@xxxxxxxxxxx To unsubscribe send a blank email to $subst('Email.Unsub')