[PCB_FORUM] Re: wasn't there a way to "mirror" geometries?

George,
How did you manage to mirror a module? I tried it and the mirror command does not apply to a single unit which is a module. I could mirror only components, but not clines/shapes which are also part of the module. I tried with 15.7 Performance. 

Robert

george.h.patrick@xxxxxxxxxxxxx wrote:
Yep. -- 
George Patrick
*Tektronix, Inc.*
Central Engineering, EDS Applications Support

P.O. Box 500, M/S 39-512
Beaverton, OR 97077-0001
Å 503-627-5272 (voice)     Æ 503-627-5587 (fax)
http://www.tektronix.com <http://www.tektronix.com/> http://www.pcb-designer.com <http://www.pcb-designer.com/> 


/*"Off-Grid and Proud of it!"*/

    -----Original Message-----
    *From:* icu-pcb-forum-bounce@xxxxxxxxxxxxx
    [mailto:icu-pcb-forum-bounce@xxxxxxxxxxxxx] *On Behalf Of
    *gnieski_mike@xxxxxxx
    *Sent:* Monday, January 14, 2008 12:26
    *To:* icu-pcb-forum@xxxxxxxxxxxxx
    *Subject:* [PCB_FORUM] Re: wasn't there a way to "mirror" geometries?

    Never tried to mirror a module, works ok?

    ------------------------------------------------------------------------
    *From:* icu-pcb-forum-bounce@xxxxxxxxxxxxx
    [mailto:icu-pcb-forum-bounce@xxxxxxxxxxxxx] *On Behalf Of
    *george.h.patrick@xxxxxxxxxxxxx
    *Sent:* Monday, January 14, 2008 3:14 PM
    *To:* icu-pcb-forum@xxxxxxxxxxxxx
    *Subject:* [PCB_FORUM] Re: wasn't there a way to "mirror" geometries?
We typically try to do stuff like this as a module. Especially 
    when we are trying to exactly replicate the circuit.  Then it can
    be easily moved/rotated/mirrored without needing to reassign anything.
-- George Patrick 
    *Tektronix, Inc.*
    Central Engineering, EDS Applications Support

    P.O. Box 500, M/S 39-512
    Beaverton, OR 97077-0001
    Å 503-627-5272 (voice)     Æ 503-627-5587 (fax)
http://www.tektronix.com <http://www.tektronix.com/> http://www.pcb-designer.com <http://www.pcb-designer.com/> 


    /*"Off-Grid and Proud of it!"*/

        -----Original Message-----
        *From:* icu-pcb-forum-bounce@xxxxxxxxxxxxx
        [mailto:icu-pcb-forum-bounce@xxxxxxxxxxxxx] *On Behalf Of
        *Gene Carman
        *Sent:* Monday, January 14, 2008 12:09
        *To:* icu-pcb-forum@xxxxxxxxxxxxx
        *Subject:* [PCB_FORUM] wasn't there a way to "mirror" geometries?

        I have to match line and shape of some clines...  is there a
        way to copy and mirror this lines...  of course I'll also have
        the issue of needing to reassign the new nets to them.  Anyone
have any ideas for this? 
        These are not just matched length, but also matched curves and
shapes of clines.

Other related posts: