[PCB_FORUM] Re: wasn't there a way to "mirror" geometries?

From: "Gene Carman" <gcarman@xxxxxxxxxxxx>
To: <icu-pcb-forum@xxxxxxxxxxxxx>
Date: Mon, 14 Jan 2008 13:09:19 -0800

Thanks Gary...  I could not remember where that command was...  or what
sequence it took to get it there.    

 

________________________________

From: icu-pcb-forum-bounce@xxxxxxxxxxxxx
[mailto:icu-pcb-forum-bounce@xxxxxxxxxxxxx] On Behalf Of Macindoe, Gary
Sent: Monday, January 14, 2008 12:19 PM
To: icu-pcb-forum@xxxxxxxxxxxxx
Subject: [PCB_FORUM] Re: wasn't there a way to "mirror" geometries?

 

Gene,

 

Sure, after you have hold of the line(s), just RMB to Mirror Geometry.

 

Gary

 

  

Gary E. MacIndoe
PCB Design Engineer
Fort Collins, Colorado

amd.com

gary.macindoe@xxxxxxx

________________________________

From: icu-pcb-forum-bounce@xxxxxxxxxxxxx
[mailto:icu-pcb-forum-bounce@xxxxxxxxxxxxx] On Behalf Of Gene Carman
Sent: Monday, January 14, 2008 1:09 PM
To: icu-pcb-forum@xxxxxxxxxxxxx
Subject: [PCB_FORUM] wasn't there a way to "mirror" geometries?

 

I have to match line and shape of some clines...  is there a way to copy
and mirror this lines...  of course I'll also have the issue of needing
to reassign the new nets to them.  Anyone have any ideas for this?  

 

These are not just matched length, but also matched curves and shapes of
clines.

References:

[PCB_FORUM] wasn't there a way to "mirror" geometries?
From: Gene Carman

[PCB_FORUM] Re: wasn't there a way to "mirror" geometries?
From: Macindoe, Gary

[PCB_FORUM] Re: wasn't there a way to "mirror" geometries?

Other related posts: