In 15.2 you have the "Pad/pad direct connect" under the Physical (Line/Via) rule set. You can set it to any of the following: - All Allowed - Via/Pin Allowed - Via/Via Allowed - Not Allowed Havn't checked if it's available in previous releases. /Jan -----Original Message----- From: William Billereau [mailto:william.billereau@xxxxxxx] Sent: den 9 mars 2005 15:45 To: icu-pcb-forum@xxxxxxxxxxxxx Subject: [PCB_FORUM] vias hole and SMT pads Hello all again. Is there a way in Allegro to check (some kind of DRCs) that via holes are not inside the SMT pad and maybe if a minimum distance is respected. I had a look in Constraints but did not find anything. Thanks. William. ----------------------------------------------------------- To subscribe/unsubscribe: Send a message to icu-pcb-forum-request@xxxxxxxxxxxxx with a subject of subscribe or unsubscribe To view the archives of this list please login at //www.freelists.org. Our list name is icu-pcb-forum or go to //www.freelists.org/archives/icu-pcb-forum/ Problems or Questions: Send an email to icu-pcb-forum-admins@xxxxxxxxxxxxx Want to post a job listing ? DON'T DO IT HERE! Better yet, join our jobs listing forum. SUBSCRIBE: icu-jobs-forum-subscribe@xxxxxxxxxx POST: icu-jobs-forum@xxxxxxxxxx ----------------------------------------------------------- ----------------------------------------------------------- To subscribe/unsubscribe: Send a message to icu-pcb-forum-request@xxxxxxxxxxxxx with a subject of subscribe or unsubscribe To view the archives of this list please login at //www.freelists.org. Our list name is icu-pcb-forum or go to //www.freelists.org/archives/icu-pcb-forum/ Problems or Questions: Send an email to icu-pcb-forum-admins@xxxxxxxxxxxxx Want to post a job listing ? DON'T DO IT HERE! Better yet, join our jobs listing forum. SUBSCRIBE: icu-jobs-forum-subscribe@xxxxxxxxxx POST: icu-jobs-forum@xxxxxxxxxx -----------------------------------------------------------