[PCB_FORUM] Re: update shapes...

Kevin,
I just had the same thing happen to me yesterday.
If you do a Dynamic shape Report (Tools/Report/Dynamic shape) it should tell you where they are...or in my case, where it "thought" it was.
There was no shape on inner5 at that location??? See attached image.
And yes...Dbdoctor did not clean it up. I had to go back to my backup.



Regards,
Mark

Kevin McCowan wrote:
Ok, me again.
My Setup/drawing options says I have 2 out of date shapes.
I cannot figure out which they are.
Or how to update them.
I ran dbdoctor and it made no difference.
Reported nothing back.
I hope I didn't use up all of my December help credits yet!

Any ideas?

Kevin McCowan
Sr. PCB Designer
TSI Telsys
-----------------------------------------------------------
To subscribe/unsubscribe:     Send a message to icu-pcb-forum-request@xxxxxxxxxxxxx
    with a subject of subscribe or unsubscribe

To view the archives of this list please login at
http://www.freelists.org. Our list name is icu-pcb-forum
or go to http://www.freelists.org/archives/icu-pcb-forum/

Problems or Questions:
    Send an email to icu-pcb-forum-admins@xxxxxxxxxxxxx

Want to post a job listing ?  DON'T DO IT HERE!  Better yet, join our jobs listing forum.

SUBSCRIBE:  icu-jobs-forum-subscribe@xxxxxxxxxx
POST:       icu-jobs-forum@xxxxxxxxxx
-----------------------------------------------------------

_____________________________________________________________________________
Scanned by IBM Email Security Management Services powered by MessageLabs. For more information please visit http://www.ers.ibm.com
_____________________________________________________________________________

JPEG image

JPEG image

Other related posts: