[PCB_FORUM] Re: update shapes...

Mark,
I run 15.2 S43 on Solaris 8.
This is what I get when click the out of shape button:
(See attached).
I have positive shapes - that may be the difference.
All the buttons referring to shapes give reports when click on them.

Julian

Mark Salberg wrote:

Julian,
That is true for unassigned shapes, but not "out of date shapes.


Mark

Mark

Julian Ungureanu wrote:

When you go to "Setup - dwg options", there is a yellow box you can click on.
That fires a report, where you can click on the X or Y coordinate of your shape.
And it takes you right there.
Pretty neat.

Julian

Kevin McCowan wrote:

Ok, me again.
My Setup/drawing options says I have 2 out of date shapes.
I cannot figure out which they are.
Or how to update them.
I ran dbdoctor and it made no difference.
Reported nothing back.
I hope I didn't use up all of my December help credits yet!

Any ideas?

Kevin McCowan
Sr. PCB Designer
TSI Telsys
-----------------------------------------------------------
To subscribe/unsubscribe:     Send a message to icu-pcb-forum-request@xxxxxxxxxxxxx
    with a subject of subscribe or unsubscribe

To view the archives of this list please login at
http://www.freelists.org. Our list name is icu-pcb-forum
or go to http://www.freelists.org/archives/icu-pcb-forum/

Problems or Questions:
    Send an email to icu-pcb-forum-admins@xxxxxxxxxxxxx

Want to post a job listing ?  DON'T DO IT HERE!  Better yet, join our jobs listing forum.

SUBSCRIBE:  icu-jobs-forum-subscribe@xxxxxxxxxx
POST:       icu-jobs-forum@xxxxxxxxxx
-----------------------------------------------------------

-- 
Thanks,
Julian 


"Opinions expressed are strictly my own and 
not necessarily those of Cisco Systems, Inc."
  

---