When you go to "Setup - dwg options", there is a yellow box you can
click on.
That fires a report, where you can click on the X or Y coordinate of
your shape.
And it takes you right there.
Pretty neat.
Julian
Kevin McCowan wrote:
Ok, me again. My Setup/drawing options says I have 2 out of date shapes. I cannot figure out which they are. Or how to update them. I ran dbdoctor and it made no difference. Reported nothing back. I hope I didn't use up all of my December help credits yet!
Any ideas?
Kevin McCowan
Sr. PCB Designer
TSI Telsys
-----------------------------------------------------------
To subscribe/unsubscribe: Send a message to icu-pcb-forum-request@xxxxxxxxxxxxx
with a subject of subscribe or unsubscribe
To view the archives of this list please login at //www.freelists.org. Our list name is icu-pcb-forum or go to //www.freelists.org/archives/icu-pcb-forum/
Problems or Questions: Send an email to icu-pcb-forum-admins@xxxxxxxxxxxxx
Want to post a job listing ? DON'T DO IT HERE! Better yet, join our jobs listing forum.
SUBSCRIBE: icu-jobs-forum-subscribe@xxxxxxxxxx POST: icu-jobs-forum@xxxxxxxxxx -----------------------------------------------------------
To view the archives of this list please login at //www.freelists.org. Our list name is icu-pcb-forum or go to //www.freelists.org/archives/icu-pcb-forum/
Problems or Questions: Send an email to icu-pcb-forum-admins@xxxxxxxxxxxxx
SUBSCRIBE: icu-jobs-forum-subscribe@xxxxxxxxxx POST: icu-jobs-forum@xxxxxxxxxx -----------------------------------------------------------