[PCB_FORUM] Re: trace impedance report

Yes, I can see it now. That was so obvious. Advisor always defines the copper thickness/weight. It made me think about my graduate advisor...

Thank you for your help.
Gennadiy


Joe.witten wrote:

Go to > Tools> Setup Advisor>
click "Next" once then "Edit Cross-Section"
-----Original Message-----
From: icu-pcb-forum-bounce@xxxxxxxxxxxxx [mailto:icu-pcb-forum-bounce@xxxxxxxxxxxxx] On Behalf Of Gennadiy Kiryukhin
Sent: Wednesday, November 23, 2005 11:30 AM
To: icu-pcb-forum@xxxxxxxxxxxxx
Subject: [PCB_FORUM] Re: trace impedance report

    I have "Allegro PCB Design 220 (PCB Studio)". It does not say
    anything else in the About window. Assuming I have the right
    software version/product, how would I define the copper weight?

    Gennadiy

    Gerry Meier wrote:

Please state what product you are using? whether it is Allrgro
Studio Studio Performace or Expert. The tool level may influence
the answer.
In Allegro Performace and Expertyou set up the dielectric
thickness and copper thickness in Cross section.
Gerry Meier
Sr. PCB Designer
Freedom CAD Services, Inc.
Voice: (603) 864-1300 x1350
AL Voice: (256) 417-6944
Email: gerry.meier@xxxxxxxxxxxxxx <mailto:gerry.meier@xxxxxxxxxxxxxx>
visit our website at<http://www.freedomcad.com


    ------------------------------------------------------------------------
    From: icu-pcb-forum-bounce@xxxxxxxxxxxxx
    [mailto:icu-pcb-forum-bounce@xxxxxxxxxxxxx] On Behalf Of
    Christian Deldicque
    Sent: Wednesday, November 23, 2005 3:02 AM
    To: icu-pcb-forum@xxxxxxxxxxxxx
    Subject: [PCB_FORUM] Re: trace impedance report

Allegro PCB SI product, let you set up that.
------------------------------------------------------------------------
From: icu-pcb-forum-bounce @freelists.org [mailto:icu-pcb-forum-bounce@xxxxxxxxxxxxx] On
Behalf Of Gennadiy Kiryukhin
Sent: Tuesday, November 22, 2005 7:52 PM
To: icu-pcb-forum@xxxxxxxxxxxxx
Subject: [PCB_FORUM] Re: trace impedance report

    Then what??  Where do you define the copper weight?

    rajendran.velayudhan@xxxxxxxxx wrote:

    In reports you can see New/edit.There you select net impeadance.....

        -----Original Message-----
        From: icu-pcb-forum-bounce@xxxxxxxxxxxxx
        [mailto:icu-pcb-forum-bounce@xxxxxxxxxxxxx] On Behalf Of
        Hamid Awais
        Sent: Tuesday, November 22, 2005 3:52 PM
        To: icu-pcb-forum@xxxxxxxxxxxxx
        Cc: hawais@xxxxxxxxxxxxxxxx
        Subject: [PCB_FORUM] trace impedance report

        Hello Allegro Guru's:

        Does Allegro (any version/flavor) opt to generate any report
        regarding Trace impedances?

        Thanks,

        Hamid



    Confidentiality Notice

    The information contained in this electronic message and any
    attachments to this message are intended
    for the exclusive use of the addressee(s) and may contain
    confidential or privileged information. If
    you are not the intended recipient, please notify the sender at
    Wipro or Mailadmin@xxxxxxxxx immediately
    and destroy all copies of this message and any attachments.




Other related posts: