[PCB_FORUM] Re: trace impedance report

I have "Allegro PCB Design 220 (PCB Studio)". It does not say anything else in the About window. Assuming I have the right software version/product, how would I define the copper weight?

Gennadiy

Gerry Meier wrote:

Please state what product you are using? whether it is Allrgro Studio Studio Performace or Expert. The tool level may influence the answer.
In Allegro Performace and Expertyou set up the dielectric thickness and copper thickness in Cross section.
Gerry Meier
Sr. PCB Designer
Freedom CAD Services, Inc.
Voice: (603) 864-1300 x1350
AL Voice: (256) 417-6944
Email: gerry.meier@xxxxxxxxxxxxxx <mailto:gerry.meier@xxxxxxxxxxxxxx>
visit our website at<http://www.freedomcad.com


------------------------------------------------------------------------
From: icu-pcb-forum-bounce@xxxxxxxxxxxxx [mailto:icu-pcb-forum-bounce@xxxxxxxxxxxxx] On Behalf Of Christian Deldicque
Sent: Wednesday, November 23, 2005 3:02 AM
To: icu-pcb-forum@xxxxxxxxxxxxx
Subject: [PCB_FORUM] Re: trace impedance report

Allegro PCB SI product, let you set up that.
------------------------------------------------------------------------
From: icu-pcb-forum-bounce @freelists.org [mailto:icu-pcb-forum-bounce@xxxxxxxxxxxxx] On Behalf Of Gennadiy Kiryukhin
Sent: Tuesday, November 22, 2005 7:52 PM
To: icu-pcb-forum@xxxxxxxxxxxxx
Subject: [PCB_FORUM] Re: trace impedance report

Then what??  Where do you define the copper weight?

rajendran.velayudhan@xxxxxxxxx wrote:

In reports you can see New/edit.There you select net impeadance.....

    -----Original Message-----
    From: icu-pcb-forum-bounce@xxxxxxxxxxxxx
    [mailto:icu-pcb-forum-bounce@xxxxxxxxxxxxx] On Behalf Of Hamid Awais
    Sent: Tuesday, November 22, 2005 3:52 PM
    To: icu-pcb-forum@xxxxxxxxxxxxx
    Cc: hawais@xxxxxxxxxxxxxxxx
    Subject: [PCB_FORUM] trace impedance report

    Hello Allegro Guru's:

    Does Allegro (any version/flavor) opt to generate any report
    regarding Trace impedances?

    Thanks,

    Hamid



Confidentiality Notice

The information contained in this electronic message and any attachments to this message are intended
for the exclusive use of the addressee(s) and may contain confidential or privileged information. If
you are not the intended recipient, please notify the sender at Wipro or Mailadmin@xxxxxxxxx immediately
and destroy all copies of this message and any attachments.



Other related posts: