[PCB_FORUM] Re: test points in 15.7

If you have your min pad size set to the same size as your standard via,
testprep will not replace them.  The min pad size should be the minimum
testpoint pad size allowed.


-----Original Message-----
From: icu-pcb-forum-bounce@xxxxxxxxxxxxx
[mailto:icu-pcb-forum-bounce@xxxxxxxxxxxxx] On Behalf Of sfeehan@xxxxxxxxxxx
Sent: Tuesday, January 06, 2009 1:53 PM
To: icu-pcb-forum@xxxxxxxxxxxxx
Subject: [PCB_FORUM] test points in 15.7


Hi All,

When setting up test points in 15.7 and I run the test prep
with replace via selected allegro adds test point properties to vias
without replacing them....has anyone seen this?

With all the same settings if I add a tp manually it works fine, it replaces
the via with my selected tp via.

Thanks,
Steve

____________________________________________________________
Click here to find experienced pros to help with your home improvement
project.
http://thirdpartyoffers.netzero.net/TGL2231/fc/PnY6rc1zNYB1fxo8se8qcC9uzIbyY
pdrkIUt0rHerz0Q8jwuWuiwH/
-----------------------------------------------------------
To subscribe/unsubscribe: 
Send a message to icu-pcb-forum-request@xxxxxxxxxxxxx
with a subject of subscribe or unsubscribe

To view the archives of this list go to
http://www.freelists.org/archives/icu-pcb-forum/

Problems or Questions:
Send an email to icu-pcb-forum-admins@xxxxxxxxxxxxx
-----------------------------------------------------------

-----------------------------------------------------------
To subscribe/unsubscribe: 
Send a message to icu-pcb-forum-request@xxxxxxxxxxxxx
with a subject of subscribe or unsubscribe

To view the archives of this list go to 
http://www.freelists.org/archives/icu-pcb-forum/

Problems or Questions:
Send an email to icu-pcb-forum-admins@xxxxxxxxxxxxx
-----------------------------------------------------------

Other related posts: