> On some jobs, we re-route traces and then we got rhombuses > (rotated squares) on same clines intersections. It is the same > net, connection is done but it causes that delete clines (not > clines segs) deletes only part before or after these squares. > > What and where to change to remove these squares and make > complete clines? Some screenshots would be helpful. But I think I understand your issue: one or more of the sides of the rhombus is not a cline but rather a collection of clines that look to the eye as one continuous trace - so instead of doing "delete clines" once you must do it mulitple times to clear up all the little stubs? If such is the case, you could delete one such short cline which would implicitly make the others part of a dangline cline(s). Do this for all the rhombuses , then you could scrub all the affected nets with SKILL routine find_dlines HTH, Chris Walters local Cadence guru (Apple) _______________________________________________ Join Excite! - http://www.excite.com The most personalized portal on the Web! ----------------------------------------------------------- To subscribe/unsubscribe: Send a message to icu-pcb-forum-request@xxxxxxxxxxxxx with a subject of subscribe or unsubscribe To view the archives of this list go to http://www.freelists.org/archives/icu-pcb-forum/ Problems or Questions: Send an email to icu-pcb-forum-admins@xxxxxxxxxxxxx -----------------------------------------------------------