Hello.
On some jobs, we re-route traces and then we got rhombuses (rotated squares) on
same clines intersections.
It is the same net, connection is done but it causes that delete clines (not
clines segs) deletes only part before or after these squares.
What and where to change to remove these squares and make complete clines?
Thanks in advance.
William.
=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=
| Billereau William | PCB Designer |
| | Tel: (+4122) 76 73403 |
| CERN TS/DEM | william.billereau@xxxxxxx |
| 1211 Geneve 23 Switzerland | Société: AMEC-SPIE/Electrotech |
=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=