Hi all, I think I do understand the question since I also miss such feature. Problem stated: - to not to have Via too close to SMD pin Partial Solution:- enable same net DRC (problem is that it checks all other rules and often creates many unwanted DRCs)
Other possibility- set a rule for "Solder mask to Solder mask" spacing assuming that Vias are not covered (problem is that this is one global rule for a whole design)
regards, Robert Macindoe, Gary wrote:
Hey Pat, Not exactly sure what you are asking here. Need a little clarification!Gary E. MacIndoeAdvanced Micro Devices PCB Design Engineer Longmont, Colorado -----Original Message----- From: icu-pcb-forum-bounce@xxxxxxxxxxxxx [mailto:icu-pcb-forum-bounce@xxxxxxxxxxxxx] On Behalf Of westfeldt Sent: Friday, January 19, 2007 6:43 AM To: icu-pcb-forum@xxxxxxxxxxxxx Subject: [PCB_FORUM] same net rules Is there no way in Allegro to have the same net rules apply only to certain rules? The one I always need is via to smd pin, but I would not want all the rest of the rules to have same net application. Patrick Westfeldt, Jr. North Boulder Circuit Design westfeldt_nbcd@xxxxxxxxx 720-406-0887 c 720-272-5822 -----------------------------------------------------------To subscribe/unsubscribe: Send a message to icu-pcb-forum-request@xxxxxxxxxxxxxwith a subject of subscribe or unsubscribe To view the archives of this list go to //www.freelists.org/archives/icu-pcb-forum/ Problems or Questions: Send an email to icu-pcb-forum-admins@xxxxxxxxxxxxx ----------------------------------------------------------- -----------------------------------------------------------To subscribe/unsubscribe: Send a message to icu-pcb-forum-request@xxxxxxxxxxxxxwith a subject of subscribe or unsubscribe To view the archives of this list go to //www.freelists.org/archives/icu-pcb-forum/ Problems or Questions: Send an email to icu-pcb-forum-admins@xxxxxxxxxxxxx -----------------------------------------------------------
-----------------------------------------------------------To subscribe/unsubscribe: Send a message to icu-pcb-forum-request@xxxxxxxxxxxxx
with a subject of subscribe or unsubscribe To view the archives of this list go to //www.freelists.org/archives/icu-pcb-forum/ Problems or Questions: Send an email to icu-pcb-forum-admins@xxxxxxxxxxxxx -----------------------------------------------------------