Hey Pat, Not exactly sure what you are asking here. Need a little clarification! Gary E. MacIndoe Advanced Micro Devices PCB Design Engineer Longmont, Colorado -----Original Message----- From: icu-pcb-forum-bounce@xxxxxxxxxxxxx [mailto:icu-pcb-forum-bounce@xxxxxxxxxxxxx] On Behalf Of westfeldt Sent: Friday, January 19, 2007 6:43 AM To: icu-pcb-forum@xxxxxxxxxxxxx Subject: [PCB_FORUM] same net rules Is there no way in Allegro to have the same net rules apply only to certain rules? The one I always need is via to smd pin, but I would not want all the rest of the rules to have same net application. Patrick Westfeldt, Jr. North Boulder Circuit Design westfeldt_nbcd@xxxxxxxxx 720-406-0887 c 720-272-5822 ----------------------------------------------------------- To subscribe/unsubscribe: Send a message to icu-pcb-forum-request@xxxxxxxxxxxxx with a subject of subscribe or unsubscribe To view the archives of this list go to //www.freelists.org/archives/icu-pcb-forum/ Problems or Questions: Send an email to icu-pcb-forum-admins@xxxxxxxxxxxxx ----------------------------------------------------------- ----------------------------------------------------------- To subscribe/unsubscribe: Send a message to icu-pcb-forum-request@xxxxxxxxxxxxx with a subject of subscribe or unsubscribe To view the archives of this list go to //www.freelists.org/archives/icu-pcb-forum/ Problems or Questions: Send an email to icu-pcb-forum-admins@xxxxxxxxxxxxx -----------------------------------------------------------