[PCB_FORUM] Re: rooms and areas (beginner with performance)

I have always used a Constraint Area for this. And assigned the
appropriate

Spacing and Physical constraint sets. Only trouble is that the
constraint does not follow

The component when moving. You can create a Alternate and lock it in
place that way.

 

dm

 

________________________________

From: icu-pcb-forum-bounce@xxxxxxxxxxxxx
[mailto:icu-pcb-forum-bounce@xxxxxxxxxxxxx] On Behalf Of
sjchar3@xxxxxxxxxxxx
Sent: Monday, August 20, 2007 9:21 AM
To: icu-pcb-forum@xxxxxxxxxxxxx
Subject: [PCB_FORUM] rooms and areas (beginner with performance)

 

group: I have a BGA and I would like to route 4 mil trace between pins,
and only a certain via would be used in this location. The rest of the
board is 8 mil traces. Do i set up a room, area or region?  

Thanks Austin for you earlier reply.

Thanks again. 

________________________________

Check Out the new free AIM(R) Mail
<http://pr.atwola.com/promoclk/100122638x1081283466x1074645346/aol?redir
=http%3A%2F%2Fwww%2Eaim%2Ecom%2Ffun%2Fmail%2F>  -- Unlimited storage and
industry-leading spam and email virus protection.

Other related posts: