[PCB_FORUM] Re: pcb-si

At the basic level, SI is extremely useful for defining topologies (i.e.
the order in which nets are routed.)  I would suggest you start with
this before you move on to full-blown simulation.

We don't have Concept (we use ViewDraw) and it can still be used
perfectly alright.  OK, there may be a couple of glitches like "you
should always do 'this' after you load in a netlist", but it's fairly
straightforward.

BTW, the training manual for SI is about 500 pages.

Cheers,
Richard

>>> sjcharles@xxxxxxx 25/02/2005 9:42:15 a.m. >>>
we have this pcb-si, but no one to drive it. Is it necessary to have
concept HDL to run pcb-si? Also where is a good place to start learning
this

Thanks in advance
Sam

-----------------------------------------------------------
To subscribe/unsubscribe: 
        Send a message to icu-pcb-forum-request@xxxxxxxxxxxxx 
        with a subject of subscribe or unsubscribe

To view the archives of this list please login at
http://www.freelists.org. Our list name is icu-pcb-forum
or go to http://www.freelists.org/archives/icu-pcb-forum/ 

Problems or Questions:
        Send an email to icu-pcb-forum-admins@xxxxxxxxxxxxx 

Want to post a job listing ?  DON'T DO IT HERE!  
Better yet, join our jobs listing forum.

SUBSCRIBE:  icu-jobs-forum-subscribe@xxxxxxxxxx 
POST:       icu-jobs-forum@xxxxxxxxxx 
-----------------------------------------------------------

NOTICE: This message contains privileged and confidential
information intended only for the use of the addressee
named above. If you are not the intended recipient of
this message you are hereby notified that you must not
disseminate, copy or take any action in reliance on it.
If you have received this message in error please
notify Allied Telesyn Research Ltd immediately.
Any views expressed in this message are those of the
individual sender, except where the sender has the
authority to issue and specifically states them to
be the views of Allied Telesyn Research.
-----------------------------------------------------------
To subscribe/unsubscribe: 
        Send a message to icu-pcb-forum-request@xxxxxxxxxxxxx
        with a subject of subscribe or unsubscribe

To view the archives of this list please login at
http://www.freelists.org. Our list name is icu-pcb-forum
or go to http://www.freelists.org/archives/icu-pcb-forum/

Problems or Questions:
        Send an email to icu-pcb-forum-admins@xxxxxxxxxxxxx

Want to post a job listing ?  DON'T DO IT HERE!  
Better yet, join our jobs listing forum.

SUBSCRIBE:  icu-jobs-forum-subscribe@xxxxxxxxxx
POST:       icu-jobs-forum@xxxxxxxxxx
-----------------------------------------------------------

Other related posts: