[PCB_FORUM] Re: non allegro rs274x gerbers into allegro?

 
Never have had any luck with 274x translations from other systems, but I
usually can import 274x into Valor, write 274c out of valor, convert the
aperture list into an art_aper.txt file and import the 274c into
Allegro.
 
-- 
George Patrick
Tektronix, Inc.
Central Engineering, EDS Applications Support
P.O. Box 500, M/S 39-512
Beaverton, OR 97077-0001
* 503-627-5272 (voice)     * 503-627-5587 (fax)
<http://www.tektronix.com/> 
http://www.tektronix.com     <http://www.pcb-designer.com/>
http://www.pcb-designer.com
 
"Off-Grid and Proud of it!"

-----Original Message-----
From: icu-pcb-forum-bounce@xxxxxxxxxxxxx
[mailto:icu-pcb-forum-bounce@xxxxxxxxxxxxx] On Behalf Of Dharma
Kemp-Bresett
Sent: Thursday, April 03, 2008 14:51
To: icu-pcb-forum@xxxxxxxxxxxxx
Subject: [PCB_FORUM] non allegro rs274x gerbers into allegro?


Hi Everyone,
Is there a way to get 274x gerbers output from some other CAD/CAM
program to read into allegro? The general error I seem to be getting is
"N codes not supported" I have tried everything I can think of and none
of it is working. Some of you must have run into this before.....?
Thanks in advance,
Dharma
 

KAW/USA Ltd. 
39 Simon Street, #4 
Nashua, NH 03060 
603-886-8711 x212 
603-881-8763 fax 

Confidentiality Notice: This email and any accompanying documents
contain information that is confidential, privileged or exempt from
disclosure under applicable law and is intended for the exclusive use of
the addressee. This information is private and protected by law. If you
are not the intended recipient, or have received this email in error,
you are hereby notified that any disclosure, copying, distribution or
use of the contents of this document in any manner is strictly
prohibited.

Other related posts: