Hi Dave, Thanks, I somehow thought that was the answer... :-) I may have found an alternate workaround but am still vetting it so can't be 100% sure quite yet. Thanks again, Dharma KAW/USA Ltd. 39 Simon Street, #4 Nashua, NH 03060 603-886-8711 x212 603-881-8763 fax Confidentiality Notice: This email and any accompanying documents contain information that is confidential, privileged or exempt from disclosure under applicable law and is intended for the exclusive use of the addressee. This information is private and protected by law. If you are not the intended recipient, or have received this email in error, you are hereby notified that any disclosure, copying, distribution or use of the contents of this document in any manner is strictly prohibited. _____ From: Dave Elder [mailto:dave.elder@xxxxxxxxxx] Sent: Thursday, April 03, 2008 6:12 PM To: icu-pcb-forum@xxxxxxxxxxxxx Subject: [PCB_FORUM] Re: non allegro rs274x gerbers into allegro? Hi Dharma, Generally speaking it's not possible. Howver, I have written Skill code to translate Gerbers from several tools with some success. I generally need to customise the code each time I run it. Not fun! Cheers, Dave Dharma Kemp-Bresett wrote, On 4/04/2008 10:50 a.m.: Hi Everyone, Is there a way to get 274x gerbers output from some other CAD/CAM program to read into allegro? The general error I seem to be getting is "N codes not supported" I have tried everything I can think of and none of it is working. Some of you must have run into this before.....? Thanks in advance, Dharma KAW/USA Ltd. 39 Simon Street, #4 Nashua, NH 03060 603-886-8711 x212 603-881-8763 fax Confidentiality Notice: This email and any accompanying documents contain information that is confidential, privileged or exempt from disclosure under applicable law and is intended for the exclusive use of the addressee. This information is private and protected by law. If you are not the intended recipient, or have received this email in error, you are hereby notified that any disclosure, copying, distribution or use of the contents of this document in any manner is strictly prohibited.