[PCB_FORUM] Re: nets shorted to gnd plane
- From: "Thurlow DeHorsey" <tdehorsey@xxxxxxxxxxxx>
- To: <icu-pcb-forum@xxxxxxxxxxxxx>
- Date: Mon, 20 Jul 2009 16:34:22 -0400
Sam,
Allegro does not run a drc check to the gerber formats. That is left for
the valor check, typically completed at a fab house. We have been
scorched a few times on the same issue, including one today.
The cost of a valor license is extremely high, when you include the
training and annual maintenance. Make sure your fab house completes
this check.
Thurlow
________________________________
From: icu-pcb-forum-bounce@xxxxxxxxxxxxx
[mailto:icu-pcb-forum-bounce@xxxxxxxxxxxxx] On Behalf Of
sjchar3@xxxxxxxxxxxx
Sent: Monday, July 20, 2009 3:54 PM
To: icu-pcb-forum@xxxxxxxxxxxxx
Subject: [PCB_FORUM] nets shorted to gnd plane
Group, I sent gerbers out and board house pointed out nets were shorted
to plane. I ran DRC and I didn't have nets shorted errors, this
shouldn't be.
Sam
________________________________
A Good Credit Score is 700 or Above. See yours in just 2 easy steps!
<http://pr.atwola.com/promoclk/100126575x1221323041x1201367261/aol?redir
=http://www.freecreditreport.com/pm/default.aspx?sc=668072%26hmpgID=62%2
6bcd=JulystepsfooterNO62>
Other related posts: