[PCB_FORUM] Re: move by command line

The syntax to place the components is x x_coord y_coord.
If you want to move the components a specific distance then the syntax
is ix ??? or iy ???
 
Rgrds
 
Peter Hughes,
PCB Designer,
Concurrent Technologies,
4 Gilberd Close,
Newcomen Way,
Colchester,
Essex,
CO4 4WN.
Tel: +44 1206 752626
Fax: +44 1206 751116
-----Original Message-----
From: icu-pcb-forum-bounce@xxxxxxxxxxxxx
[mailto:icu-pcb-forum-bounce@xxxxxxxxxxxxx] On Behalf Of Peter P.
Sent: 28 April 2006 14:44
To: icu-pcb-forum@xxxxxxxxxxxxx
Subject: [PCB_FORUM] move by command line
 
I am having severe brain failure this morning. I need to tweak a
footprint, I want to move groups of pins and just type the location on
the command line, but I cannot remember the proper syntax. Any help
would be appreciated. I grab a group of pins and then what do I type on
the command line to put them exactly where I need them?
 
Peter

Other related posts: