[PCB_FORUM] Re: mouse change w/15.5

If you get used to it its easy. I found it to be much faster than the old
way to manuveur around a board.
 
Mike
 

  _____  

From: icu-pcb-forum-bounce@xxxxxxxxxxxxx
[mailto:icu-pcb-forum-bounce@xxxxxxxxxxxxx] On Behalf Of David Greig
Sent: Friday, February 17, 2006 4:24 AM
To: icu-pcb-forum@xxxxxxxxxxxxx
Subject: [PCB_FORUM] Re: mouse change w/15.5


env variable,  "unset no_dynamic_zoom"
 
why on earth it's even an option? about as much use as strokes.
 
Best Regards
 
David Greig
______________________________
GigaDyne Ltd
Buchan House
Carnegie Campus
Dunfermline KY11 8PL
United Kingdom
t: +44 (0)1383 624 975
www.gigadyne.co.uk <http://www.gigadyne.co.uk/> 
______________________________
 

  _____  

From: icu-pcb-forum-bounce@xxxxxxxxxxxxx
[mailto:icu-pcb-forum-bounce@xxxxxxxxxxxxx] On Behalf Of Gary MacIndoe
Sent: 16 February 2006 21:34
To: icu-pcb-forum@xxxxxxxxxxxxx
Subject: [PCB_FORUM] mouse change w/15.5



Hey guys,

 

I'm not sure what's going on with my mouse, or if it's even a result of
upgrading to 15.5.

 

Before, while on 15.2, clicking the middle mouse button would continue
zooming in if I had just zoomed in.

If I had just zoomed out, the middle mouse button would continue the zooming
out when clicked.

 

Now, clicking the middle mouse button zooms me in, whether I just zoomed out
or in.

 

Not a big deal, but anyone have any clues as to where this is set?

 

Thanks!

 

Gary E. MacIndoe

PCB Design Engineer

Advanced Micro Devices

Longmont, Colorado

 


-- 

Virus scanned by Lumison.

Other related posts: