[PCB_FORUM] Re: electrical constraint manager, timing

  • From: "Austin Franklin" <austin@xxxxxxxxxxxx>
  • To: <icu-pcb-forum@xxxxxxxxxxxxx>
  • Date: Mon, 4 Jul 2005 21:15:17 -0400

Hi Sam,

> Group: I have more questions since posting this so i will add
> another question. Any response is appreciated.
> If the clk signal is the target, do i set this up in MIN/MAX
> Propagation Delays of under the Total Etch Length? Do i need to
> set up in both places?

Do you need it to be a specific length, or only relative to the group?  If
relative to the group, then no, you only set it up in relative propagation
delay.  If you require a specific length, then you set it in total etch
length.

Regards,

Austin

-----------------------------------------------------------
To subscribe/unsubscribe: 
        Send a message to icu-pcb-forum-request@xxxxxxxxxxxxx
        with a subject of subscribe or unsubscribe

To view the archives of this list please login at
//www.freelists.org. Our list name is icu-pcb-forum
or go to //www.freelists.org/archives/icu-pcb-forum/

Problems or Questions:
        Send an email to icu-pcb-forum-admins@xxxxxxxxxxxxx

Want to post a job listing ?  DON'T DO IT HERE!  
Better yet, join our jobs listing forum.

SUBSCRIBE:  icu-jobs-forum-subscribe@xxxxxxxxxx
POST:       icu-jobs-forum@xxxxxxxxxx
-----------------------------------------------------------

Other related posts:

  1. Home
  2. icu-pcb-forum
  3. Archive
  4. 07-2005