[PCB_FORUM] diff pair in 16.0

Group: Where do i set up the diff pairs? I'm in CM under electrical -> 
Differential.?

Phase tolerance = 10 mil 
Min Line spacing =5 mil
?primary gap = 7 mil. 

But while routing I get 3 mil .

Is the primary gap the spacing between the pairs or is it min line spacing?

I need 7 mil trace with 5 mil spacing.

Thanks
Sam
________________________________________________________________________
Check Out the new free AIM(R) Mail -- Unlimited storage and industry-leading 
spam and email virus protection.

Other related posts: