Have you tried to place the symbol somewhere in the middle of the board or on the edge? If you are placing a part to close to the edge of a board and the "world" view is close to the edge, any text, lines, etc will prevent placement. If that is your problem you should be able to change the max extents of the world view. Shirley Librarian -----Original Message----- From: sjcharles@xxxxxxx [mailto:sjcharles@xxxxxxx] Sent: Monday, September 20, 2004 11:07 AM To: icu-pcb-forum@xxxxxxxxxxxxx Subject: [PCB_FORUM] could not fit symbol Group: I did a update to pcb and sot23_5 got deleted. Using quickplace i get the error "could not fit symbol". Tried using "place manually" to no avail. I'm using 15.2. thanks Sam ----------------------------------------------------------- To subscribe/unsubscribe: Send a message to icu-pcb-forum-request@xxxxxxxxxxxxx with a subject of subscribe or unsubscribe To view the archives of this list please login at //www.freelists.org. Our list name is icu-pcb-forum or go to //www.freelists.org/archives/icu-pcb-forum/ Problems or Questions: Send an email to icu-pcb-forum-admins@xxxxxxxxxxxxx Want to post a job listing ? DON'T DO IT HERE! Better yet, join our jobs listing forum. SUBSCRIBE: icu-jobs-forum-subscribe@xxxxxxxxxx POST: icu-jobs-forum@xxxxxxxxxx ----------------------------------------------------------- ----------------------------------------------------------- To subscribe/unsubscribe: Send a message to icu-pcb-forum-request@xxxxxxxxxxxxx with a subject of subscribe or unsubscribe To view the archives of this list please login at //www.freelists.org. Our list name is icu-pcb-forum or go to //www.freelists.org/archives/icu-pcb-forum/ Problems or Questions: Send an email to icu-pcb-forum-admins@xxxxxxxxxxxxx Want to post a job listing ? DON'T DO IT HERE! Better yet, join our jobs listing forum. SUBSCRIBE: icu-jobs-forum-subscribe@xxxxxxxxxx POST: icu-jobs-forum@xxxxxxxxxx -----------------------------------------------------------