the way we did it before we started using modiles was copy the circuit and then go to logic>assign ref des -----Original Message----- From: icu-pcb-forum-bounce@xxxxxxxxxxxxx [mailto:icu-pcb-forum-bounce@xxxxxxxxxxxxx] On Behalf Of Soledad Attia Sent: Friday, January 11, 2008 10:41 AM To: icu-pcb-forum@xxxxxxxxxxxxx Subject: [PCB_FORUM] copy circuit in Allego Hi All, I'm working with Allegro version 15.1 using Viewlogic for the schematic and would like to duplicate a circuit from the PCB Allegro side; When I copy the circuit, the new components reference designators come up with a "*", but Allegro does not allow for me to manually change them and assign a new reference designator. Does anyone know how to do this or How to translate this change to the schematic? Thanks in advance for your help Soledad Attia ENG Designer Printronix Inc Irvine, Ca ----------------------------------------------------------- To subscribe/unsubscribe: Send a message to icu-pcb-forum-request@xxxxxxxxxxxxx with a subject of subscribe or unsubscribe To view the archives of this list go to //www.freelists.org/archives/icu-pcb-forum/ Problems or Questions: Send an email to icu-pcb-forum-admins@xxxxxxxxxxxxx ----------------------------------------------------------- ----------------------------------------------------------- To subscribe/unsubscribe: Send a message to icu-pcb-forum-request@xxxxxxxxxxxxx with a subject of subscribe or unsubscribe To view the archives of this list go to //www.freelists.org/archives/icu-pcb-forum/ Problems or Questions: Send an email to icu-pcb-forum-admins@xxxxxxxxxxxxx -----------------------------------------------------------