[PCB_FORUM] Re: clines can not be found.

Hi Diane,

I had a similar problem with a Skill routine.
It was solved by clearing the select set. This unsets the find bit.
Try typing "skill axlClearSelSet" in your command window.

Cheers, Dave

Dickoff, Diane J wrote:



I had a crash in my allegro. I ran dbdoctor, updated my drcs, picked up all the traces and vias and moved 0,0, and rebooted by desktop. But when I try to delete a via or cline it says there is no element to be found (and they are selected in the find menu). The only way I can get it to see the cline is to move it (without stretching etch) and then delete it---I can't get anything to delete a via.



Has anyone seen this before and/or do you have any suggestions on how to fix it?



Thanks, Diane Dickoff

Intel Corporation

Hillsboro, Oregon





begin:vcard
fn:Dave Elder
n:Elder;Dave
org:Tait Electronics
adr:;;PO Box 1645;Christchurch;;;New Zealand
email;internet:dave.elder@xxxxxxxxxx
title:PCB Design Manager
tel;work:+64 3 3580327
tel;cell:+64 21 37 37 25
url:http://www.taitworld.com
version:2.1
end:vcard

Other related posts: