[PCB_FORUM] can this be accomplished easily in the autorouter?

Hello Everyone,
I have a couple of questions I hope someone can answer for me. We have a
customer with a pads board. He would like to make some changes that in
allegro would be relatively easy but are apparently a time-consuming process
in pads. I have little or no experience with the autorouter but the thought
was if it is that much easier in allegro perhaps it would be similarly
easier in the autorouter. 
 
What we would like to do is export DSN to autorouter then:
1.) Change all diffpairs from 3.94mil trace and 3.94mil air gap to 3.5mil
trace 4.38 air gap?

2.) Change all diffpairs from 3.94mil trace and 3.94mil air gap to 3.5mil
trace 5.00 air gap.  This may cause the need to neck traces and or slide
some of the pairs.

First of all CAN this be done easily in the autorouter? And, if so, a
ballpark range for approximately how time consuming it would be...

I know this isn't very much info but it is what I have at the moment.

Thanks in advance,

Dharma

 
 

KAW/USA Ltd. 
39 Simon Street, #4 
Nashua, NH 03060 
603-886-8711 x212 
603-881-8763 fax 

Confidentiality Notice: This email and any accompanying documents contain
information that is confidential, privileged or exempt from disclosure under
applicable law and is intended for the exclusive use of the addressee. This
information is private and protected by law. If you are not the intended
recipient, or have received this email in error, you are hereby notified
that any disclosure, copying, distribution or use of the contents of this
document in any manner is strictly prohibited.

Other related posts: