[PCB_FORUM] Re: altium DSN to spectra error

Dharma,
        I took a look at the top of a CCT file, and found the statement:
        
             (write_resolution MIL 10000)

        I think this sets the unit and the number of decimal places for
        the design.

        Try reducing the number of decimal place in your Altium design
        file and then export the DSN/CCT file again.

Regards,
       Mike Finczak
       CopperCAD Design
       www.CopperCAD.com
       905-488-8958



 

________________________________

From: icu-pcb-forum-bounce@xxxxxxxxxxxxx
[mailto:icu-pcb-forum-bounce@xxxxxxxxxxxxx] On Behalf Of Dharma
Kemp-Bresett
Sent: Monday, April 28, 2008 2:03 PM
To: icu-pcb-forum@xxxxxxxxxxxxx
Subject: [PCB_FORUM] altium DSN to spectra error


Hi Everyone,
I am trying to load a dsn output from altium into the autorouter but I
keep getting the same error:
" Resolution value <MIL 10000> in your design file is too fine. The
program will not run do to possible arithmetic overflow. Please correct
the resolution value and rerun your job"
I assume this means it would rather see the design in inches however
there does not appear to be an inches output option in altium ( only MM
and MILS). Am I understanding this error correctly? If so have any of
you encountered this before?
Thanks in Advance,
Dharma
 
 
 

KAW/USA Ltd. 
39 Simon Street, #4 
Nashua, NH 03060 
603-886-8711 x212 
603-881-8763 fax 

Confidentiality Notice: This email and any accompanying documents
contain information that is confidential, privileged or exempt from
disclosure under applicable law and is intended for the exclusive use of
the addressee. This information is private and protected by law. If you
are not the intended recipient, or have received this email in error,
you are hereby notified that any disclosure, copying, distribution or
use of the contents of this document in any manner is strictly
prohibited.


-----------------------------------------------------------
To subscribe/unsubscribe: 
Send a message to icu-pcb-forum-request@xxxxxxxxxxxxx
with a subject of subscribe or unsubscribe

To view the archives of this list go to 
http://www.freelists.org/archives/icu-pcb-forum/

Problems or Questions:
Send an email to icu-pcb-forum-admins@xxxxxxxxxxxxx
-----------------------------------------------------------

Other related posts: