[PCB_FORUM] altium DSN to spectra error

Hi Everyone,
I am trying to load a dsn output from altium into the autorouter but I keep
getting the same error:
" Resolution value <MIL 10000> in your design file is too fine. The program
will not run do to possible arithmetic overflow. Please correct the
resolution value and rerun your job"
I assume this means it would rather see the design in inches however there
does not appear to be an inches output option in altium ( only MM and MILS).
Am I understanding this error correctly? If so have any of you encountered
this before?
Thanks in Advance,
Dharma
 
 
 

KAW/USA Ltd. 
39 Simon Street, #4 
Nashua, NH 03060 
603-886-8711 x212 
603-881-8763 fax 

Confidentiality Notice: This email and any accompanying documents contain
information that is confidential, privileged or exempt from disclosure under
applicable law and is intended for the exclusive use of the addressee. This
information is private and protected by law. If you are not the intended
recipient, or have received this email in error, you are hereby notified
that any disclosure, copying, distribution or use of the contents of this
document in any manner is strictly prohibited.

Other related posts: